ENGLISH - 2
(2) While holding the lower part of the
metal plate (2), slide the metal plate
downward and secure it.
2
Note
� Attach the SD memory card socket before installing
the metal plate if the SD memory card socket was
attached to the printer.
7 Close the access cover (1).
1
8 Plug the AC cord and Ethernet or USB
cable into your printer, and then turn on
the power switch.
9 Press the <ENTER> button on the
operator panel.
10 Check that [ ] is selected
and press the <ENTER> button.
11 Press the scroll button several times
to select [System] and press the
<ENTER> button.
12 Press the scroll button several times
to select [Total Memory] and press the
<ENTER> button.
13 Check that the value of [Total Memory]
has increased.
- For memory expanded to 256 MB, it is
[512 MB]; for memory expanded to 512
MB, it is [768 MB].
Note
� If the value of [Total Memory] has not increased, turn
off your printer and unplug the AC cord and Ethernet or
USB cable, and then reinstall the additional RAM.
14 Press the <ON LINE> button.
To Next Page
Loading...
