Loading paper> 17
5. Set paper size dial (3) to the size of paper being used (A4
in the above example).
6. If you have two trays and you are printing from the 1st
(upper) tray, you can pull out the 2nd (lower) tray during
printing to reload it. However, if printing from the 2nd
(lower) tray, do not pull out the 1st (upper) tray. This will
cause a paper jam.
7. For face down printing, make sure the face up (rear)
stacker (3) is closed (the paper exits from the top of the
printer). Stacking capacity is approximately 250 sheets,
depending on paper weight.
8. For face up printing, make sure the face up (rear)
stacker (3) is open and the paper support (4) is extended.
Paper is stacked in reverse order and tray capacity is
approximately 100 sheets, depending on paper weight.
9. Always use the face up (rear) stacker for heavy paper
(card stock etc.).
CAUTION!
Do not open or close the rear paper exit while printing as
it may result in a paper jam.
3
4
To Next Page
Loading...
