Oki PACEMARK 4410 - Page 88

40496501TH Draft Version 88
Item No.
1
Items
Protector Gap Adjustment
(1)Range Adjustment
(2)Protector Gap
Standard Value Illustration Adjustment Method
1 Remove the Rear Cover (B), and set
Dip Switch 1 on the board to “ON”
(maintenance mode).
2 Close the access cover, and turn on
the printer while pressing Switches 7
and 10 on the operation panel. (This
starts the auto gap adjusting mode.)
The platen moves forward/ backward
up to the adjusted position.
3 When the platen stops, turn off the
printer.
1 Insert the thickness gauge between
the platen and the protector frame to
verify the protector gap value B is bet-
ween 0.12 and 0.16 mm.
Notes:
Although the adjustment should use a
range from 0.12 to 0.16mm, the configura-
tion should use a range from 0.09 to 0.2mm
2 If adjustment is required, screw down
the ribbon guide post with the Philips
screwdriver and adjust the protector
frame to make the protector gap value
B between 0.12 and 0.16 mm, then fix
the protector frame.
Notes:
a) The protector frame should be
mounted parallel with the platen, when
measured at the right/left gap measur-
ing points.
DIP Switch
Lower Cover
Rear Cover (B)
ON
OFF
1234
ON
OFF
1234
DIP SW
Temporary
Maintenance
PARKTEAR
PATH
ONLINE
RESET
GROUP
POWER
ALARM
ITEM OPTION
MENU
STORE
TOF
SHIFT
ON-LINE EPS
FRONT FEED CONFIG
LF
MicroFeed
Down
FF/LOAD
MicroFeed
Up
1
2 3 4
5
6
7
8
9 0 A B C
1
2
3
Gap Measuring Points
Ribbon Guide PostProtector Frame
Platen
B
B