40496501TH Draft Version 93
Item No. Items Standard Value Illustration Adjustment Method
Correct the printing alignment in each
"Registration1 ....7". (Note2)(Note3)
Note2)After printing, change items with
4
switch
Note3)The reverse printing position is
shifted by 0.05mm to the reference
position by pressing
4
switch or
8
and
4
switch.
4
After completing the correction,
press
6
switch to store the corrected
values to the inside of printer. (Note4)
Note4)If the
6
switch is not pressed,
the corrected values cannot be stored
and the settings are returned to the
previous set values.
Press
5
while holding
8
to print a
menu page to check the registration.
(See the left drawing)
Number
+5
+4
+3
+2
+1
0
-1
-2
-3
-4
-5
Correction dot position of reverse printing
Printing position is shifted by 0.25mm to right of the reference position.
Printing position is shifted by 0.20mm to right of the reference position.
Printing position is shifted by 0.15mm to right of the reference position.
Printing position is shifted by 0.10mm to right of the reference position.
Printing position is shifted by 0.05mm to right of the reference position.
Reference position
Printing position is shifted by 0.05mm to left of the reference position.
Printing position is shifted by 0.10mm to left of the reference position.
Printing position is shifted by 0.15mm to left of the reference position.
Printing position is shifted by 0.20mm to left of the reference position.
Printing position is shifted by 0.25mm to left of the reference position.
4
8
and
4
To Next Page
Loading...
