- 9 -
[Installation Space]
z
Select an installation location that is level and can support the weight of the machine (weight of
equipment is about 43 kg
*
for the printer and about 19 kg for the unwinder).
* Including the print cartridge and other consumables.
z
Install the machine near a power socket. Also, install the equipment so the power socket is within
easy reach so the power plug can be pulled out in an emergency.
z
Do not place things around the machine.
To install the printer and the unwinder on a stand, the stand must be at least 1050 mm wide and
500 mm deep. If you install the printer and the unwinder on a stand that is too small, they may fall off
if they are hanging over the edge of the stand.
Install the equipment according to the equipment installation space shown in the diagram.
Approximately
500 mm
100 mm or more
Approximately
1050 mm
100 mm
or more
400 mm
or more
700 mm or more
100 mm or more
Approximately
440 mm
400 mm
or more
840 mm or more
Approximately
700 mm
To Next Page
Loading...
