To Next PageTo Next Page
Need help?Do you have a question about the oklahoma joes Rider 900 and is the answer not in the manual?
General| Brand | oklahoma joes |
|---|---|
| Model | Rider 900 |
| Category | Grill |
| Language | English |
General safety warnings for pellet grills.
Explanation of safety symbols used in the manual.
Key safety precautions for operating the grill.
Required safe distances from combustible materials.
Guidelines for safe use of electrical components.
Approved fuel types and warnings for safe use.
Information on creosote buildup and its removal.
Caution against leaving the grill unattended.
Important warnings before starting the assembly process.
Instructions for installing the digital control panel.
Warning about the side hopper release handle.
Steps to install heat shields on the grill body.
Instructions for attaching the side panel.
Installing the mount for the pellet bucket.
Installing the compartment box for temperature probes.
Attaching casters and legs to the grill base.
Installing the lower shelf of the grill.
Mounting the wheels onto the grill legs.
Attaching the side shelf to the grill.
Installing the towel bar and tool hooks.
Installing the lid handle components.
Attaching the base of the smoke stack.
Installing the caps for the smoke stack.
Proper installation of the ash collection cup.
Attaching the rear hanger hooks.
Installing the heat distribution plates.
Installing the grease tent for grease management.
Installing a heat distribution plate.
Steps for installing the cooking grates.
Installing the warming racks, model dependent.
Attaching the pellet bucket to the grill.
Attaching the grease collection buckets.
Installing the handle lever components.
Installing the food probes.
Installing the probe compartment box.
Initial setup and startup for the pellet grill.
Procedures for seasoning and burn off cycles.
Proper procedure for shutting down the grill.
Steps for starting the grill after initial use.
Warning regarding touching the ignitor rod.
Overview of built-in safety features in the control software.
Diagnosing low temperatures or ER5 error codes.
Checking pellet supply and ash buildup in the firepot.
Identifying potential jams in the auger system.
Checking the auger motor for proper operation.
Steps to clear jams from the auger system.
Addressing smoke originating from the pellet hopper.
Verifying the function of the chamber temperature probe.
Verifying the function of the grilling temperature probe.
Testing the ignitor for proper operation.
Detailed steps to clear auger jams.
Information on the ER1 error code related to the auger.
Information on the ER2 error code related to the ignitor.
Information on the ER3 error code for the fan.
Information on the ER4 error code for the chamber probe.
Information on the ER5 error code for flameout.
Information on the ER6 error code for overheating.
Information on the ER7 error code for grilling probe.
Information on the 18H error for unattended unit.
Explanation of wire colors used in the electrical diagram.
Legal warning regarding lead exposure in California.
Invitation to share cooking experiences on social media.
