09
3. Product Use / 3.2 Preparation
3. Product Use / 3.3 Robot Charging
R
L
1. Remove the protective strip
2. Install side brushes and lock screw
(L for L, R for R)
1.Put the self-empty base in ground against the wall.
There should be no cliffs/stairs or objects in the area
1m to the left and right and 2m in front; connect to
supply power.
2.Turn on the power switch of the Robot and put it
into self-empty base, and connect the charging
contacts of them.
3.For first time use, please fully charge it. During the
charging, the start button flashes breathing light in
white, and it will be off when charging finished.
Charging time is about 4-5 hours.
Warm Reminder:
1.During daily use, please put the Robot into the self-empty base. Also ensure self-empty base is connected to
the power supply and the Robot power is on.
2.During daily use, pay attention to clean the charging contacts for better charging.
3.If you do not use the Robot for a long time, please fully charge it before turn it off, then store it in a ventilated
and dry place. And it is necessary to charge it once a month to protect battery.
4.If the battery is over discharged or not used for a long time, Robot may not be rechargeable. Please contact our
after-sales service for maintenance. Do not disassemble it by yourself
Before using the product, please remove the protective strip and protective film.
storage slot
Cable Outlet
OFF ON
O I
>1M
>1M
>
M
Tips:
1.Robot cannot be charged when it’s power off.
2.Please put the excess wire into storage slot, power cable can be pulled
out at both sides.
*keep objects with strong reflecting surface such as mirror or glass away
*Keep self-empty base away from direct sunlight.
To Next Page
Loading...
