Oldham 700 TP Series User Manual

OLCT 700/710 TP
Page 16 of 45 Rev. C.1 OLCT 700/710 TP Instruction Manual
3.2 Operator Interface
The operating interface is menu-driven via the two magnetic (PGM1 and PGM2) program switches located
under the target marks of the detector housing. The menu list consists of three major items that include
sub-menus as indicated below (refer to the complete Software Flow Chart in Figure 11).
Normal Operation
Current Reading and Fault Status
Calibration Mode
AutoSpan
Program Mode
View Sensor Status
Sensor Model Type
Current Software Version
Range of Detection
Serial ID address
AutoSpan Level
Days Since Last AutoSpan
Remaining Sensor Life
Sensor Heater Power
Sensor Heater Voltage
Raw Sensor Resistance
mA Output
Input Voltage Supply
Sensor Temperature
Set AutoSpan Level
Set Range
Set Serial ID
Set Heater Power
Signal Output Check
Restore Default Settings

Oldham 700 TP Series Specifications

General

Brand	Oldham
Model	700 TP Series
Category	Accessories
Language	English