*.
4.
8.
Put the new headlamp in position.
Make sure the socket points
in
the same
direction
as
it did with the old headlamp.
9.
Insert the tabs on the
aiming
ring
into the slots
in
the headlamp
assembly.
10.
Holding the aiming ring closed, insert the screws at
the end
of
the ring. Tighten the screws until the
aiming ring touches the plastic nuts on both the
top
and bottom.
0.
Do
not overtighten.
Do
not damage the vertical aiming bubble.
1
1
6-32
To Next Page
Loading...
