.,
‘
FIRST
(1):
This position gives you even more power
-
.
(but lower fuel economy) than
SECOND
(2).
You
can
use it on very steep hills,
or
in deep. snow or mud.
If
the
shift
lever is put
in
FIRST
(l),
the transaxle won’t shift
into first gear until the vehicle is going slowly enough.
..
NOTICE:
If
your front wheels can’t rotate, don’t
try
to
drive. This might ,happen if you were stuck in
very deep sand or mud- or were’up against
a
solid
object. Youxould damage your ,transaxle.
Also,
if
you stop when going uphill, don’t hold.
your vehicle there with only the accelerator
pedal. This could overheat and damage the
transaxle. Use your brakes.or
shift
into
PARK
(P)
to hold your vehicle in position on a hill.
Parking
Brake
The parking brake uses the brakes on the rear wheels.
I
To
set the parking brake,
hold the regular brake pedal
down with your right foot.
Push
down the parking
brake pedal with your left
foot.
To
release the parking brake, hold the regular brake pedal
clown with your right foot and push
the
parking brake
pd with your left foot. men you lift your left foot, the
parking brake pedal will follow it
to
the released position.
NOTICE:
Driving with the parking brake on can cause
your rear brakes
to
overheat. You may have to
replace them, and you could also damage ‘other
parts of your vehicle.
To Next Page
Loading...
