Windshield Wipers
You control the windshield
wipers by turning the band
marked
WIPER.
For a
singl’e wipi.ng cycle, turn the
band
to
MIST. Hold
it
there
until the wipers,&ut, then
let
go. The wipers will stop
after one cycle.
If
you want
more cycles, hold the band
on MIST longer.
~
For steady wiping at low speed,
turn
the band to
LO.
For
high-speed wiping,
turn
the band furtber, to
HI.
To stop
the wipers,
turn
the band to
OFF.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to.
LO,
the shorter the delay.
Be sure to clear ice and snow from the wiper blades
before using them.
If
they’re frozen to.the.windshield,
carefully loosen or thaw them.
If
your blades do become
damaged, get new blades or blade inserts.
~
Heavy snow or ice can overload your wipers.
A
circuit
breaker will stop them until the motor cools. Clear away
I
snow or ice to prevent
an
overload.
Windshield
Washer
At the top of the
multifunction lever, there’s
a paddle with the word
PUSH
on it. To spray
washer fluid on the
windshield, push the paddle.
The wipers will run for
several sweeps and then
either stop or return
to
your
preset speed.
2-27
\
To Next Page
Loading...
