FWD
(2):
Press this button to advance quickly to
another part of the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances.
You
may select stations
during
FWD
operation by using
TUNE.
PROG
(3):
Press this button to play the other side of
the tape.
00
(4):
Press
this
button to reduce background noise.
Note
that the double-D symbol will appear on the display.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
TONE:
Press this button to select a tone while playing
a
cassette. The tone will be automatically set whenever
you play a cassette tape.
SEEK:
Press the up or down arrow to search for the
next or previous selection on the tape. Your tape must
have at least three seconds of silence between each
selection for
SEER
to work.
SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then
go
on to the next selection. Press
this button again to stop scanning. The
sound
will mute,
SCAN
will
appear on the display and the tape direction
arrow
will
blink while scanning.
AM-FM:
Press
this
button to play the radio when a
tape
is
in
the player. The tape will stop but remain
in
the player.
TAPE
AUX:
If you have a tape inserted and the radio is
playing, press TAPE
AUX
to play your tape. To return
to the radio while a tape is playing, press
AM-FM.
The
inactive tape will remain safely inside the radio for
future listening.
EJECT
Press this button to remove the tape. The radio
will play. EJECT may be activated with either the
ignition or radio off. Cassettes may be loaded with the
radio and ignition
off
if
this button is pressed first.
If
you leave a cassette tape in the player while listening to
the radio, it may become warm.
CLN:
If this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean
it
as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
To Next Page
Loading...
