Windshield Wipers
The windshield wipers are controlled by turning the
band marked
WIPER.
For a single wiping cycle, turn the band to MIST. Hold
it
there until the wipers start, then let go. The wipers will
stop after one cycle.
If
you want more cycles, hold the
band on MIST longer.
For steady wiping at low speed,
turn
the band away
from you to the
LO
position. For high-speed wiping,
turn
the band further, to
HI.
To stop the wipers, move
the band to
OFF.
I
The wiper speed may be set for a long or short delay
between wipes. This can be
very
useful in light rain or
snow. Turn the band to choose the delay time. The
closer to
LO,
the shorter the delay.
Heavy snow or ice can overload your wiper motor.
A
circuit breaker
will
stop the motor until
it
cools. Clear
away snow or ice to prevent an overload.
Keep in mind that damaged wiper blades may prevent
you from seeing well enough to drive safely. To avoid
damage, be sure to clear ice and snow from the wiper
blades before using them.
If
your blades do become
damaged, get new blades or blade inserts.
To Next Page
Loading...
Need help?
General
