FWD
(2):
Press this button to advance quickly to
another part of the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances.
You
may select stations
during
FWD
operation by using TUNE.
PROG
(3):
Press this button to play the other side of
the tape.
00
(4):
Press
this
button to reduce background noise.
Note that the doub1e-D symbol will appear on the display.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks
of
Dolby Laboratories Licensing Corporation.
TONE:
Press this button to select a tone while playing a
cassette. The tone will be automatically set whenever
you play a cassette tape.
SEEK:
Press the up or down arrow to search
for
the
next or previous selection on the tape.
Your
tape must
have at least three seconds of silence between each
selection for SEEK to work.
SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound will mute
while scanning, SCAN will appear on the display and
the
tape direction arrow will blink while scanning.
AM-FM:
Press
this
button to play the radio when a
tape
is in the player. The
tape
will stop but’ remain
in
the player.
TAPE-CD:
Press this button if you have a disc loaded
in the CD player and the radio is playing, to play a
compact disc. Press
AM-FM
to return to the radio when
a compact disc is playing. Press TAPE-CD to switch
between the tape and compact disc if both are loaded.
The inactive tape or CD will remain safely inside the
radio for future listening.
EJECT
Press this button to remove the tape. The
radio will play. EJECT may be activated with either the
ignition or radio
off.
Cassettes may be loaded with the
radio and ignition off if
this
button is pressed first.
If
you leave a cassette tape in the player while listening to
the radio, it may become warm.
CLN:
If
this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your
Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
3-14
To Next Page
Loading...
