4.
Use solvent-type cleaners in a well-ventilated area
only.
If
you use them, don’t saturate the stained area.
5.
If a ring forms after spot cleaning, clean the entire
area immediately or it will set.
Using Foam-Type Cleaner on Fabric
1.
Vacuum and brush the area to remove any loose dirt.
2.
Always clean a whole trim panel or section. Mask
3.
Mix Multi-Purpose Powdered Cleaner following the
surrounding trim along stitch or welt lines.
directions on the container label.
4.
Use suds only and apply with a clean sponge. Don’t
saturate the material and don’t rub it roughly.
5.
As soon as you’ve cleaned the section, use a sponge
to remove the suds.
6.
Rinse the section with a clean, wet sponge.
7.
Wipe
off
what’s left with a slightly damp paper towel
or cloth.
8.
Dry it immediately with a blow dryer.
9.
Wipe with a clean cloth.
Using Solvent-Type Cleaner on Fabric
First, see if you have to use solvent-type cleaner at all.
Some spots and stains will clean off better with just
water and mild soap.
If
you need to use a solvent:
1.
Gently scrape excess soil from the trim material with
a clean, dull knife or scraper.
2.
Use very little cleaner, light pressure and clean cloths
(preferably cheesecloth). Cleaning should start at the
outside
of
the stain, “feathering” toward the center.
3.
Keep changing to a clean section of the cloth.
4.
When you clean a stain from fabric, immediately
dry the area with a blow dryer to help prevent a
cleaning ring.
6-45
To Next Page
Loading...
