Comfort Controls
&Audio
Systems
band; the scan will continue every few
seconds until you press
SCAN
again to
stop on a particular station. You can
also press the upper knob
(VOLUME
)
to stop the scan.
SEEK
Each time you press
SEEK,
you
will tune in the next station higher on
the radio band.
To Preset Radio Stations:
Using the four pushbuttons below the
digital display, you can set up to
14
radio stations (seven
AM
and seven
FM).
1.
Use the lower hob
(TUNE)
to tune
in the station you want.
2.
Press
SET.
The
SET
indicator will
appear on the digital screen for five
seconds.
3.
While the
SET
indicator is displayed,
press one of the four pushbuttons.
4.
Repeat steps
1-3
for each of four
AM
and four
FM
stations.
Up to three additional stations on each
band may be preset by “pairing”
pushbuttons:
1.
Tune in the desired station.
2.
Press
SET,
and within five seconds
press any two adjacent pushbuttons
at
the same time.
3.
The station can be tuned in when the
same two pushbuttons are pressed at
the same time.
To Play a Cassette Tape:
With the power
on,
insert a tape into
the cassette door. Using tapes that are
longer than
90
minutes
(45
minutes on
each side) is not recommended.
When the right indicator arrow is lit,
selections listed on the bottom side of
the cassette are playing. When the left
arrow is lit, selections listed on the top
side of the cassette are playing.
To
change sides of the tape, press the
upper control hob
(VOLUME)
while
the cassette is playing. The tape player
automatically begins playing the other
side when it reaches the end of the tape.
Fast Forward:
Press the button with
the arrow pointing in the same direction
that the tape is playing.
To
stop fast
forward, press the
STOP-EJECT
button.
Reverse:
Press the button with the
arrow pointing in the opposite direction
that the tape is playing.
To
stop reverse,
press the
STOP-EJECT
button.
STOP-EJECT:
To
stop playing a tape,
fully press this button. The cassette will
be partially ejected, and the radio will
begin playing.
To Next Page
Loading...
