Headlight High-Low Beam
Changer
To change the headlights from low
beam to high or high to low, pull the
turn signal/multifunction lever all the
way toward you. Then release
it:
When the high beams are on, a blue
.
light on the instrument panel also will
be on.
Flash-to-Pass
Flash-to-pass lets you use your high
beam headlights to signal a driver in
front of you that you want to pass;
To
use it, pull the turn signaVmu1tifunction
lever toward you.
If
Your Headlights are
Off
They’ll stay on as long as you hold the
lever there. Release the lever to turn
them off.
If
Your Headlights are
On:
No
flash-to-pass. Use the lever to
change between high and low beams, as
explained under
Headlight High-Low
Beam Changer
earlier in this section.
If
You Have Fog Lights:
They go
off
whenever the high beams
are on. When the high beams go off, the
fog lights will come on again, if the fog
light switch is on.
Instrument Panel Intensity
Control
You can brighten or dim the instrument
panel lights by rotating the control. If
you rotate the control all-the way to.
INT
your courtesy or interior lights will
come on.
Your high beam headlights will turn on.
79
To Next Page
Loading...
