Features
&
Controls
NOTICE:
Don’t drive in
2
(Second Gear) for
more than
5
miles
(8
km)
,
or at
speeds over
55
mph
(88
kwh), or
you can damage your transaxle.
Use
D
or
3
as much as possible.
Don’t
shift
into
2
unless you are
going slower than
65
mph
(105
krn/h), or you can damage your
engine.
1
(First Gear):
This position gives you
even more power (but lower fuel
economy) than
2.
You
can use it on
very steep hills, or in deep snow
or
mud. If the shift lever is put in
1,
the
transaxle won’t shift into first gear until
the vehicle is going slowly enough.
NOTICE:
If your front wheels can’t rotate,
don’t
try
to drive. This might
happen if you were stuck in very
deep sand or mud or were up
against a solid object. You could
damage your transaxle.
Also,
if you stop when going uphill,
don’t hold your vehicle there with
only the accelerator pedal. This
could overheat and damage the
transaxle. Use your brakes or shift
into
P
(Park) to hold. your vehicle.
in position on a hill.
Parking
Brake
The parking brake uses the brakes
on
.the rear wheels.
To
Set the Parking Brake:
Hold thexegular brake pedal down with
your right .foot. Push down the parking
brake pedal with your left foot. If the
ignition is
on,
the brake system warning
light will come on.
To Next Page
Loading...
