9M/FM
Stereo
with
Compact
Disc
Player
The digital display indicates information
on time or radio station frequency, the
AM or FM radio band, whether the
station is in stereo, and other radio
functions.
POWER:-Press to turn the unit on and
off
when the ignition
is
on.
VOL (Volume):
Adjusts the volume up
or down, and the bottom of the digital
screen displays the setting. For a normal
listening level preset at the factory,
press the center of the switch.
TUNE:
Press this switch to tune in
higher frequencies and lower
frequencies.
SEEK:
Press
to
tune automatically to
the next station higher on the band.
BAL (Balance):
Adjusts the lefthight
and fronthear speaker balance to your
individual taste. When you change
either adjustment, the bottom of the
digital screen will display the point of
balance
you
have selected. For the
normal setting preset at the factory,
press the left and right or front and rear
buttons at the same time.
SCAN:
Press to listen for a few seconds
to the next station on the AM
or
FM
band; the scan will continue every few
seconds until you press
SCAN
again
to
stop on a particular station.
RCL
(Recall):
Press to change between
the clock and the radio station
frequency displayed on the digital
screen.
AM/FM:
Press to switch between the
AM and FM bands.
To Preset Radio Stations
The five pushbuttons in the lower right
corner can be used to preset up to ten
radio stations (five AM and five
FM)
.
The buttons have other uses when you
are playing a compact disc.
1.
Tune the digital display to the station
you
want.
2.
Press
SET.
The
SET
indicator will
appear on the digital screen for five
seconds.
3.
While the
SET
indicator is displayed,
press one
of
the five pushbuttons.
4.
Repeat steps
1-3
for each of five AM
and five FM stations.
119
To Next Page
Loading...
