Features
&
Controls
54
If it doesn’t have a screw, pop the
cover off by inserting a dime (or
similar object) in the slot between the
covers and twisting.
first.
(2016).
2.
Lift
the
front cover
off,
bottom half
3.
Remove and replace the two batteries
4.
Reassemble the transmitter.
5.
Check the transmitter operation.
Programming
the
Module
You
will need to program your Remote
Lock Control module
if
any
of
the
Eollowing things occur:
You
replace your Remote Lock
Control transmitter;
You
add a second transmitter;
Something grounds the data encoder
You
replace the Remote Lock Control
connector in the trunk;
module.
To
program the module, you’ll need the
transmitter and a short length of wire,
about
3
feet
(1
m)
long. Then follow
these steps:
1.
Open the trunk and locate the data
encoder connector
(A).
It’s on the
right side, above the wheel well.
2.
Attach one end of the grounding wire
to the stud inside the data encoder
connector terminal.
3.
Attach the other end of the wire to a
4.
Press any button
on
the transmitter
ground
(B).
once. Wait for the loclts to fully cycle.
If you have a second portable
transmitter, press any button on it,
once, also. Wait for the loclts to fully
cycle.
Your
module is now
programmed.
5.
Disconnect the wire from the data
encoder connector and the ground.
Vehicle theft is big business, especially
in some cities. Although your
Oldsmobile has a number of theft
deterrent features, we lmow that
nothing we put on
it
can make it
impossible to steal. However, there are
ways you can help.
Key
in
the
Ignition
If you walk away
from
your vehicle .with
the keys inside, it’s an. easy target for
To Next Page
Loading...
