A
V
~ ~
rum
Signal
and
Lane Change
Indicator
The turn signal has two upward (for
Right) and two downward (for Left)
positions. These positions allow you to
signal a turn or a lane change.
To
Signal a Turn:
Move the lever all the way up or down.
When the turn is finished, the lever will
return automatically.
MPI
A
green arrow on the instrument panel
win
flash in the direction of the turn or
lane change.
To
signal a lane change, just raise or
lower the lever until the green arrow
starts to flash. Hold it there until you
complete your lane change. The lever
will return by itself when you release it.
As
you signal a turn or a lane change,
if
the arrows don’t flash but just stay on,
E
signal bulb may be burned out and
other drivers won’t see your turn signal.
If a bulb is burned out, replace it to
heir
avoid an accident.
If
the green arrows
don’t go on at all when you signal a
turn, check the fuse (see the
Index
under
Fuses
G
Circuit Breakers)
and
for burned-out bulbs.
A
warning chime
will
remind you if you
have left your turn signal on for more
than
‘/2
mile
(3
km)
of
driving.
73
To Next Page
Loading...
