FWD
(2):
Pres‘s this button to advance quickly to
another part of the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances. You may select stations
during FWD operation by using TUNE.
PROG
(3):
Press this button. to play the other side of
the tape.
(4):
Press
this
button to reduce background noise.
Note that the double-D symbol will appear on the display.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
SEEK:
Press the up or down arrow to search for the
next or previous selection on the tape. Your tape must
have at least
three
seconds of silence between each
selection for SEEK to work. After the selection has been
playing for at least eight seconds, press
the
SEEK
down
arrow to return to the beginning of the selection.
SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then
go
on to the next selection. Press
this button again to stop scanning. The sound will be
muted, SCAN will appear on the display and the tape
direction arrow will blink while scanning.
TONE:
Press this button to select a TONE while
playing a cassette. The tone will be automatically set
whenever you play a cassette tape.
AM-F”:
Press this button to play the radio when
a
tape
is in the player. The tape will stop but remain in the
player.
TAPE
AUX:
If you have a tape inserted and the radio is
playing, press TAPE AUX to play your tape. To return
to the radio while a tape is playing, press AM-FM. The
inactive tape will remain safely inside the radio for
future listening.
EJECT:
Press this button to remove the tape. The radio
will play. EJECT may be activated with either. the
ignition or radio
off.
Cassettes may be loaded with the
radio and ignition
off
if
this
button
is
pressed first.
CLN:
This message may appear on the display.
If
it
does, your cassette tape player needs to be cleaned. It
will still play tapes, but you should clean it as soon as
possible to prevent damage to your tapes and player.
See “Care ,of Your Cassette Tape Player” in the Index.
After you clean the player, press and hold EJECT for
five seconds to reset the CLN indicator. The radio will
display
---
to show the indicator was reset.
3-13
To Next Page
Loading...
