Then, without shutting
off
the engine, follow these steps:
r
3100 (Code
M)
Engine
1.
The transaxle fluid
dipstick handle is
the red loop near
the back
of
the
engine. Pull out the
dipstick and wipe
it with a clean rag
or paper towel.
3100 (Code
M)
Engine
2.
Push it back in all the way, wait three seconds and
then pull it back out again.
3.
Check both sides
of
the dipstick, and
read the lower
level. The fluid
level must be in the
cross-hatched area.
4.
If
the fluid level is in the acceptable range, push the
dipstick back in all the way.
6-18
To Next Page
Loading...
