To Next PageTo Next PageWhy Oleo-Mac Power Pump engine won't reach full speed and emits smoke?
The engine may not reach full speed and/or emit excessive smoke due to several reasons. First, ensure you are using fresh gasoline and the correct two-stroke engine oil mixture. Second, check the air filter and clean it according to the maintenance instructions. Finally, the carburetor might need adjustment.
What to do if Oleo-Mac Power Pump engine does not start or stalls?
If the engine does not start or stalls shortly after starting, there could be a couple of reasons. First, check the spark plug for a spark. If there is no spark, try again with a new spark plug (RCJ-7Y). Second, the engine might be flooded. Follow the procedure on page 18. If the engine still doesn't start, repeat the procedure with a new spark plug.
Why Oleo-Mac Power Pump engine starts, but the water flow rate is poor?
If the engine starts and rotates, but the water flow rate is poor, it might be because of excessive priming depth or a clogged suction filter. Clean the suction filter.
Instructions for handling and mixing fuel safely.
Step-by-step guide to starting the engine.
Procedure and precautions for the engine's initial use.
Safety measures related to the operating environment.
List of substances and applications that must not be used.
Instructions for handling and mixing fuel safely.
Step-by-step guide to starting the engine.
Procedure and precautions for the engine's initial use.
Safety measures related to the operating environment.
List of substances and applications that must not be used.
General| Brand | Oleo-Mac |
|---|---|
| Model | SA 30 TLA |
| Category | Water Pump |
| Language | English |
