Why Oleo-Mac Power Pump engine won't reach full speed and emits smoke?
The engine may not reach full speed and/or emit excessive smoke due to several reasons. First, ensure you are using fresh gasoline and the correct two-stroke engine oil mixture. Second, check the air filter and clean it according to the maintenance instructions. Finally, the carburetor might need adjustment.
What to do if Oleo-Mac Power Pump engine does not start or stalls?
If the engine does not start or stalls shortly after starting, there could be a couple of reasons. First, check the spark plug for a spark. If there is no spark, try again with a new spark plug (RCJ-7Y). Second, the engine might be flooded. Follow the procedure on page 18. If the engine still doesn't start, repeat the procedure with a new spark plug.
Why Oleo-Mac Power Pump engine starts, but the water flow rate is poor?
If the engine starts and rotates, but the water flow rate is poor, it might be because of excessive priming depth or a clogged suction filter. Clean the suction filter.
Lists essential safety rules for safe operation and maintenance.
Critical safety information and procedures for handling and refueling the machine.
Information on recommended fuel types, oil-fuel mixes, and cautions.
Step-by-step guide for starting the engine, including cold and flooded conditions.
Identifies common problems, their causes, and solutions for the pump.
General| Brand | Oleo-Mac |
|---|---|
| Model | SA 45 TL |
| Category | Water Pump |
| Language | English |
To Next Page
