Olimpia splendid PELER 4D - Page 48

PELER 4D
ENGLISH
EN - 18
3.4.c - Oscillation key (A1)
When the appliance is on, press this button to start or stop the air orientation
functionthroughtheverticalaps(11)(rightandleft).
Pressitoncetostartthefunction;theoscillationLEDswitcheson.
Press it a second time to stop the function.
3.4.d - Mode key (A3)
When the appliance is switched on, “normal” mode is set by default.
Press this key and the mode changes according to this sequence:
Normal ---> Natural ---> Sleep ---> Normal ---> Natural ---> ...
ThemodeLEDchangesaccordingly(the“natural”(B3a)and“sleep”(B3b)modes
arenotavailableat“silent”speed(B3c)).
The various modes work as follows:
1 - Normal(B3a):theapplianceworksconstantlyatthesetspeed.
2 - Natural(B3b): the appliance works changing air speed continu-
ously.
3 - Sleep(B3c): the appliance works changing air speed continu-
ously, reducing it down to the minimum value.
3.4.e - Timer key (A6)
When the appliance is on, by pressing this key on the display, the timer changes
according to this sequence:
00h (off) ---> 01h ---> 02h ---> 03h ---> .. 08h ---> 00h (off) ---> ..
Once the timer has been set, after a few seconds the display goes back to showing
the room temperature detected.
3.4.f - Cooling/humidier key (A2)
When the appliance is running, press this key to start or stop the cooling/humid-
ierfunction.
Pressitoncetostartthefunction;thepump(4)andthecooling/humidierLED
(B4)switchon.
Press it a second time to stop the function.