ENGLISH
EN - 32
3.5.13 - Silent function
Noise is reduced when this function is activated.
3.5.14 - Turbo function
• In TURBO mode, the fan motor functions at a very high speed in a way to reach the temperature set in
the least time possible.
3.6 - ADJUSTING AIR FLOW DIRECTION
Adjustthedirectionoftheaircorrectlyinordertopreventtheowofairfrombeingannoying(gure3)or
generating irregular temperatures in the room.
a. Adjust the horizontal louvres using the remote control.
b.Adjusttheverticallouvresmanually(gure35).
Before adjusting the vertical louvres, disconnect the electric power supply.
3.6.1-Adjustmentoftheverticaldirectionoftheair(high-low)(gure“36”)
The air conditioner automatically adjusts the vertical direction of the air, according to the operational mode.
Perform this function when the unit is operating.
Holdthe“SWING”(3)keydownontheremotecontrol(gure35)tomovethelouvresinthedesireddirection.
• The SWING button is disabled when the air conditioner is not operational (even when the TIMER
ON is set).
• Do not activate the air conditioner for long periods with the air downwards in cooling or
dehumidicationmodes.
Otherwise, humidity may form on the surface of the horizontal louvres, which could fall onto the
oororfurnishings.
• Do not move the horizontal and vertical slits manually.
Always use the SWING button. If directed manually, malfunctioning may occur. If louvre
malfunctioning occurs, stop the conditioner and re-start it.
• When the conditioner is switched on immediately after it has been switched off, the horizontal
louvresmaynotmoveforapprox.10seconds.
• The angle of opening of the horizontal louvres must not be too small, since performance in
COOLINGorHEATINGmodemaynotbeperfectfortheowofairthatistoonarrow.
• Never activate the unit with the horizontal louvres in closed position.
• When the conditioner is connected to the power supply (initial power supply), the horizontal
louvresmaymakeanoisefor10seconds.Itisnormaloperation.