Olimpia splendid Unico EDGE - 2.4.2 - Condensate Discharge Preparation

UNICO EDGE R32
EN - 17
ENGLISH
• Drilltheholesforanchoringthewallxingbracketusingthe4holesattheendsofthebracketasindi-
catedonthedrillingtemplateasarstpossibility(g.6).
• Ifthewallisofpoorconsistency,itisadvisabletousealargernumberofxinganchors.
 Thebracketoffersmultiplepossibilitiesbothinthenumberofxingsandintheirposition.
• Thegreaterweightoftheapplianceisontheright,thereforeitispreferabletoensureamoresolidxing
fromthisside.
Carefully check the characteristics and consistency of the wall in order to possibly choose wall
plugs specic for particular situations.
The manufacturer will not be held liable for any underestimates made in the
structural consistency of the anchor prepared by the installer.
Therefore, pay utmost attention to the foregoing operation that could cause
serious injury/damage to people/property if carried out incorrectly.
• Wheninstallingmodelsequippedwithheatingpump,ifnocondensatedischargewasbuiltintothewall
(seeparagraph2.4.2),inordertodrainthecondensateitwillbenecessarytodrillaholethroughthe
wallinthepositionshownonthetemplate.
2.4.2 - Preparing the condensate discharge
• Asregardsmachineswithheatpump,acondensationdrainpipe(g.1-ref.N)(supplied)tobeinserted
inthespecicconnection(A)(g.7).
 Removethecap(B)(g.7)beforeinsertingthecondensationdrainpipe.
 Whenthemaxlevelisreached,asolenoidvalveensuresthecondensatewillowoutfromtheinternal
tray.
• Forcold-onlymachines,connectthecondensatedischargepipeifyouintendrunningtheunitatlow
outdoortemperatures(lowerthan23°C).
• Sincecondensatedrainsbygravity,theremustbeaminimumslopeofatleast3%ateverypointofthe
dischargeline.Usearigidorexibletubehavinganinsidediameterofatleast16mm.
• Ifthelineemptiesintoaseweragesystem,installasiphonbeforethepointinwhichthepipereaches
themaindischarge,atleast300mmbelowtheinletfromtheunit(g.8).
• Ifthedrainpipedrainsintoavessel(tankorothercontainer),thiscontainershouldnotbesealedand
thedrainpipeshouldnotremainimmersedinthewater(seeg.9).
• Theholethroughwhichthecondensatepipepassesshouldalwaysslopetowardstheoutside(seeg.
10).
 Theexactpositioninwhichtoplacethepipeinlet,ascomparedtothemachine,isshownonthedrilling
template.
Make sure, in this case, that the water expelled outward does not damage or
disturb persons or property.
During the winter this type of drainage may cause sheets of ice to form.