Olimpia splendid VERTIGO - Page 38

EN - 14
ENGLISH
WARNING: When the appliance enters heating mode, the air duct (2) over-
heats.Evenafterswitchingo,theappliancemaystillbehot.
The appliance is equipped with an integrated protection sensor which auto-
maticallyswitchesotheapplianceifthelatterisaccidentallyoverturned
oroverheatsexcessively.
In this case:
a.switchotheappliancebymeansoftheON/OFFswitch(8)anddiscon-
nect the power plug;
b. let the appliance cool down for 15/20 minutes;
c. restart the appliance.
If the issue persists, disconnect the plug from the power outlet and please
contact the retailer or the technical assistance service.
3.4.e.3- Puriermode
Toactivate/deactivatethismode,presskey(A10),thedisplayshowsthesymbol“U”.
 Thismodeswitchesoautomaticallyafter1hourofoperation.
3.4.e.4 - Sleep mode
Toactivate/deactivatethismode,presskey(A3),thedisplayshowsthesymbol“LL”.
This function automatically lowers fan speed to a minimum.
This mode cannot be activated in heating mode.
3.4.e.5 - Wi-Fi function
To activate this function, keep the ON/OFF key(D1)onthedisplaypressedforapproximately6/7seconds
untiltheapplianceemitsthreeconsecutivebeepsandonthedisplayappearsthesymbol“F”.
To activate this function, keep the ON/OFF key(D1)onthedisplaypressedforapproximately6/7seconds
untiltheapplianceemitsthreeconsecutivebeeps.
The instructions for connection to the WiFi network and for use oft he App are available on
www.olimpiasplendid.com in the download area.
3.4.e.6 - Visualization of ambient temperature
Tovisualizethedetectedambienttemperature,pressthekey(D3).
3.4.f - Timer key (can only be activated from the remote control)
When the appliance is on, press this key and the timer changes according to this sequence:
0h (Timero󰀨) ---> 1h ---> 2h ---> 3h ---> .. 8h ---> 0h (Timero󰀨) ---> ..