Step 3 - Secure the back cover in place
Position the back cover over the battery and
slide up until it clicks into place.
Secure lanyard (optional)
The lanyard eyelet is located on the left side
of the phone. It can be identified by the two
cut-outs in close proximity on the white
phone casing. We recommend removing
the material from the lanyard (via the black
side squeeze buckle) prior to securing it to
the phone to simplify the threading process.
Step 1: Thread the black lanyard cord
To thread the lanyard cord, insert the thin
black lanyard cord into the top lanyard
eyelet cut-out. Use the pointy end of the
silver tool to push the black lanyard cord
towards the bottom lanyard eyelet cut-out.
Insert the pointy end of the silver tool into
the bottom lanyard eyelet cut-out and use it
to pull the lanyard cord out through the
bottom cut-out. Continue pulling the looped
end of the lanyard cord through the bottom
cut-out until the black side squeeze buckle
touches the phone.
Step 2: Secure black lanyard cord
To Next Page
Loading...
