1308S20016 4-1
BASIC MACHINE COMPONENTS AND SET UP
Before proceeding further, take a moment to familiarize yourself with the identification of
the machine components as shown in the illustration below.
SET UP
1. Carefully remove the Model 1308 from the box. Check to make sure the order is
complete, and it has not been damaged during shipment.
2. Place the unit in a suitable location which provides an adequate working space.
The location must be sturdy, level, and capable of holding 60lbs. per machine.
3. Remove all packaging materials and shipping restraints such as plastic ties and
tape.
4. Raise the handle to full extension.
5. Place film roll in designated area towards the rear of the unit.
6. Thread film through the film pinch roller as shown below.
To Next Page
Loading...
Need help?
General