1308S20017 5-1
OPERATING PROCEDURES
1. Plug the power cord into a properly grounded outlet. Avoid the use of extension
cords.
2. Pusher rocker switch to “On” position (red light indicates on).
NOTE: It should take approximately 15 minutes for the machine to warm up to
operating temperature.
3. Place tray carrier in its designated area with the dowel pins facing down
4. Place filled tray in tray carrier. Make sure the food in the tray is not higher than
the flange of the tray
5. Grasp the corners of the film and pull it straight across the tray going a ¼ inch
past the flange of the tray
6. Pull handle down with both hands until it stops. Hold the handle down for
approximately 2 seconds.
7. Lift the handle to its upright position.
8. Remove tray from tray carrier.
9. Repeat steps 4 thru 8
CAUTION
IT IS NOT RECOMMENDED TO LEAVE THE MACHINE ON WHEN IT WILL BE OUT
OF OPERATION FOR AN EXTENDED PERIOD OF TIME.
Rev 2-24-09
To Next Page
Loading...
Need help?
General