Sensors Battery Installation
Olymbros Z3 sensor is powered by one 9V battery(NOT included), open the battery cover by a flat-blade
screwdriver and install one 9V carbon battery.
Sensors Power On and Mounting
Slide the Power Switch to the ON position, the LED indicator will flash a red light, the red light will
disappear and then the sensors are powered up.
Place the sensors on the tree approximately 3-9 ft. High at a slight downward angle.
It can also be placed outside your house/campsite/yard/garage/driveway to detect movement from humans,
cars, and animals, which helps keep you safe.
Note: Every time you Install or remove
the battery, please make sure that the
sensors are turned off.
Note:
1. The antenna should be placed on the LEFT when
mounting the sensors.
2. After the sensor starts working, the red LED light will
flash after each trigger within one minute and no longer
flash after one minute.
To Next Page
Loading...