28 En
En
J USING THE FLASH
1
Push the flash lever up.
• The flash pops up.
2
Set the flash mode by repeatedly pressing #.
• The flash mode changes in the sequence shown below (when all
modes are available).
• To prevent the flash from firing, press down on the top of the flash to
retract it.
3
Press the shutter button halfway.
• In conditions where the flash will fire, # lights.
4
Press the shutter button fully to take the picture.
TIPS
Flash working range
W (max.): Approx. xx m – xx m (xx ft. – xx ft.)
T (max.) : Approx. xx m – xx m (xx ft. – xx ft.)
Auto-flash (No indication)
The flash fires automatically in low light or backlight conditions.
Red-eye reduction flash (!
!!
!)
The red-eye reduction flash mode reduces this phenomenon by emitting pre-
flashes before firing the regular flash.
Fill-in flash (#
##
#)
The flash always fires every time the shutter button is released.
Flash off ($
$$
$)
The flash does not fire even in low light conditions.
Slow synchronization #
##
#SLOW1 #
##
#SLOW2 !#
!#!#
!#SLOW1
1st curtain (front curtain) #
##
#SLOW1 (factory default setting):
Adjusts the flash for slow shutter speeds.
2nd curtain (rear curtain) #
##
#SLOW2:
The 2nd curtain fires the flash just before the shutter closes.
No indication
(Auto-flash)
#Slow (Slow
synchronization)
To Next Page
Loading...
