193
Troubleshooting
Miscellaneous
11
(When the camera is connected to a PC or printer.
Possible cause Corrective action Ref. page
The printer fails to connect.
PC was selected on
the monitor after
connecting to the
printer with a USB
cable.
Remove the USB cable, and start again from step
1 of “Connecting the camera to a printer”.
P. 17 0
The printer does not
support PictBridge.
Refer to the printer’s instruction manual or contact
the manufacturer.
—
The camera is not recognized by the PC.
The USB driver has
not been installed.
It is necessary to install the USB driver for
Windows 98/98SE. For installation instructions,
see “DIGITAL CAMERA-PC CONNECTION
OPERATION MANUAL” on the CD-ROM.
—
The camera has not
been turned on.
Press the power switch to turn the camera on. P.24
To Next Page
Loading...
