Why are my Olympus CAMEDIA E 10 pictures blurred?
If your Olympus camcorder pictures are blurred, out of focus, or not sharp, ensure you're using the AF target mark by positioning the subject in the viewfinder's center or using auto lock focus. Also, hold the camera steady with both hands, elbows at your side, and fingers grasping the camera. Clean the lens and store the camera in its case when not in use.
Why Olympus Camcorder cannot operate, monitor and control panel blank?
If your Olympus camcorder's monitor and control panel are blank, first, move the power switch to the ON position. If it has been in sleep mode for over an hour, move the power switch to the OFF position and then back to ON. Also, check the batteries: remove and re-insert them correctly, insert fresh batteries, or recharge if using lithium polymer or Ni-MH batteries. If in cold weather, warm the batteries before inserting them.
Why Olympus CAMEDIA E 10 Camcorder built-in flash does not fire?
If the built-in flash on your Olympus camcorder does not fire, press the flash button to raise the flash unit. If there's sufficient light, the flash won't fire; use fill-in flash mode if you need it.
What to do if my Olympus CAMEDIA E 10 says card is full?
If the Olympus camcorder's card is full, replace it with a fresh one. Alternatively, delete unneeded images, transfer images to a computer and then delete them, or format the card.
How to fix too bright pictures on Olympus Camcorder?
If your Olympus camcorder is taking pictures that are too bright, switch off the flash mark or close the built-in flash. You can also adjust the exposure compensation or remove the source of light from the picture. Switching to or center weighted averaging metering, or using spot metering with AE lock might also help.
Why is my Olympus CAMEDIA E 10 picture too dark?
If your Olympus camcorder picture is too dark, and the flash mark is blinking, it indicates the subject is too dark, so use the flash. Alternatively, if the center of the picture was very bright, try switching to center weighted averaging metering, or use spot metering by centering the subject under the spot metering mark and then using AE lock to achieve the correct exposure.
Why Olympus Camcorder does not operate when I press the shutter button?
If your Olympus camcorder is not operating when you press the shutter button, replace the batteries and check the card access lamp. If it's blinking, wait until it stops before removing the batteries. If shooting multiple exposures and the memory gauge is full, wait until at least one bar goes off before resuming. Also, ensure the mode dial is set to P, A, S, or M, and that a card is inserted without a protect seal.
How to improve Olympus CAMEDIA E 10 Camcorder monitor visibility?
If you're having trouble seeing the monitor on your Olympus camcorder, try adjusting the monitor brightness. You can also use your hand to block sunlight glare.
Why Olympus CAMEDIA E 10 Camcorder monitor and viewfinder displays are different?
If the monitor and viewfinder displays on your Olympus camcorder are different, press the monitor button to switch on the monitor. Ensure the mode dial is set to P, A, S, or M. If in playback mode, press the monitor button to return to shooting mode. If these steps don't solve the issue, refer to 'Cannot operate the camera, monitor and control panel blank'.
What to do if cannot play back images on Olympus Camcorder monitor?
If you cannot play back images on the Olympus camcorder's monitor, insert a card with images or take a picture. Set the mode dial to playback, or rapidly press the monitor button twice after setting the mode dial to P, A, S, or M. If the issue persists, refer to 'Cannot operate the camera, monitor and control panel blank'.
To Next Page
General