Olympus FC-WR - Attaching the commander to the camera; Removing the commander

21
EN
Attaching the commander to the camera Attaching the commander to the camera
x
Make sure that both the commander and the camera are turned off.
x
Dirt or moisture on the electrical contacts may cause a malfunction. Wipe off any
dirt or moisture before you attach the commander to the camera.
1
Hold down the latch release button (
1
),
and slide the latch in the direction of the
arrow (
2
).
Latch
Latch release button
2
Insert the commander all the way into the
hot shoe.
Hot shoe
Electrical contacts
3
Slide the latch in the direction of the
arrow.
Removing the commander
Perform Step 1 of the above procedure and remove the commander from the hot
shoe.