14
En
1 Press the Y# button repeatedly to select the flash mode and press H.
2 Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
3 Press the shutter button completely to take the picture.
1 Press the NY button to select [Y] and press H.
2 Press the shutter button fully to take the picture.
The self-timer lamp lights for approximately 10 seconds after
the shutter button is pressed, then starts blinking. After blinking
for approximately 2 seconds, the picture is taken.
To save the battery power, the camera automatically enters sleep mode and
stops operating if not used for approximately 3 minutes. Operate the shutter
button or zoom lever to reactivate the camera.
If the camera is not operated for approximately 12 minutes after the camera
enters sleep mode, it automatically retracts the lens and turns off. To resume
operation, turn on the power again.
Icon Flash Mode Description
AUTO
Flash auto The flash fires automatically in low light or backlight
conditions.
! Red-eye This emits pre-flashes for red-eye reduction.
#
Fill-in The flash fires regardless of the available light.
$ Flash off The flash does not fire.
Flash Modes
Self-Timer
Self-timer Lamp
Power Save Feature
d4347_e_basic_00_bookfile.book Page 14 Wednesday, July 11, 2007 10:44 AM
To Next Page
Loading...
