Olympus IR-300 - Adjusting the Image Processing Function (PIXEL MAPPING)

103
8
Settings
Adjusting the image processing
function (PIXEL MAPPING)
The pixel mapping feature allows the camera to check and adjust the CCD
and image processing functions. It is not necessary to operate this function
frequently. Approximately once a year is recommended. Wait at least one
minute after taking or viewing pictures to allow the pixel mapping function
to perform properly.
Top menu [MODE MENU] [SETUP] [PIXEL MAPPING]
g“Using the menus” (P. 18)
1 When [START] is displayed,
press i.
• The [BUSY] bar is displayed during pixel
mapping. When pixel mapping is
finished, the screen returns to the mode
menu.
Note
• If you turn the camera off during pixel mapping, start again from Step 1.
START
PIXEL MAPPING
s
X
VOLUME
VIDEO OUT