~
Adding sound to still pictures
YES
/
NO
Sound is recorded for about 4 seconds.
• Select a picture with
<![), and select [YES] with 6 '\},then press
@ to begin recording.
• The [BUSY] bar will be temporarily displayed.
8E~SE
CJ)
r::
o
:t=:
~
Q)
a.
o
~
r::
Q)
:E
Protected pictures cannot be erased. Cancel protection before erasing protected pictures.
Once erased, pictures cannot be restored. Check each picture before erasing to avoid
accidentally erasing pictures you want to keep.
• When erasing the picture
in
the internal memory, do not insert the card into the camera.
• When erasing the picture from the card, insert a card into the camera in advance.
• You can confirm on the monitor whether the internal memory
or
card is being used.
~
"Using the internal memory or card" (P. 63)
SEL. IMAGE Erase by selecting the single-frame
• Use the arrow pad to select the picture, and press @ to add V .
• Press @ again to cancel the selection.
• When all individual pictures to be erased have been marked,
press
fir/If{.
• Select [yES], and press
@.
ALL ERASE Erase all the pictures
in
the internal memory or the card
• Select [YES], and press
@.
34EN
To Next Page
Loading...
