Inserting and removing the picture card
19
Before operating your camera
Preparations
Continued on next page
Insert the card into the spring-
loaded card slot as shown.
The card will lock into place when
fully inserted.
Push the card in as far as it will go.
To remove the card, press it in again
to eject it.
Close the picture card cover
before closing the connector
cover.
Close the connector cover while
pressing A in the direction
indicated by the arrow.
If the connector cover does not fully
close, check that the brown picture
card cover is closed.
Card
A
000e_kihonhen.book Page 19 Tuesday, February 10, 2004 2:30 PM
To Next Page
Loading...
