Power on/off
22
Preparations
Before operating your camera
When closing the lens barrier, do not press the lens barrier hard against the
lens as this could damage the lens or cause malfunction.
When viewing pictures (Playback mode)
Turn the camera on.
Î Press the q.
The picture you have just taken is
displayed.
To save battery power, the camera
automatically turns off after about 3
minutes of non-operation.
If the q is pressed while the lens
barrier is open (shooting mode), the
camera will enter playback mode.
Turn the camera off.
Î Press q again.
The monitor turns off.
When the lens barrier is opened, the camera returns to the shooting mode.
When connecting the camera to the computer
Turn the camera on.
Î g“Connecting the camera to the computer” (P.48)
Turn the camera off.
Î g“Disconnecting the camera from your computer” (P.60)
$04.03.17 15:30
000e_kihonhen.book Page 22 Tuesday, February 10, 2004 2:30 PM
To Next Page
Loading...
