59
EN
59
EN
For the operation method, refer to (P. 42).
d Settings Menu 2
Adjusting the image processing function d [Pixel Mapping]
• This function has already been adjusted at factory shipping, and no
adjustment is needed right after purchase. Approximately once a year is
recommended.
• For best results, wait at least one minute after taking or viewing pictures
before performing pixel mapping. If the camera is turned off during pixel
mapping, be sure to perform it again.
To adjust the image processing function
Press the A button when [Start] (Submenu 2) is displayed.
• The check and adjustment of the image processing function starts.
Adjusting the brightness of the monitor d [s]
1 Use FG (arrow pad) to adjust the brightness
while viewing the monitor, and then press the A
button.
MENU
Back
s
Playing back images on a TV d [TV Out]
The TV video signal system varies depending on the countries and regions.
Before viewing camera images on your TV, select the video output according
to your TV’s video signal type.
Submenu 2 Submenu 3 Application
NTSC/PAL
NTSC
Connecting the camera to a TV in North America,
Taiwan, Korea, Japan, and so on.
PAL
Connecting the camera to a TV in European
countries, China, and so on.
HDMI Out
480p/576p
720p
1080i
Set the signal format to be given priority. If
the TV setting does not match, it is changed
automatically.
HDMI Control
Off Operate with the camera.
On Operate with the TV remote control.
• For the connection method, refer to “Viewing camera images on TV” (P. 76).
To Next Page
Loading...
