USG-400
Installation and Connection 3-18 ISSUE1
WARNING
Do not connect an instrument other than the
THUNDERBEAT or SONICBEAT to the transducer socket.
Otherwise, the system will malfunction and injury and/or
equipment damage may also result.
CAUTION
Do not touch the transducer plug contacts. Static electricity
that was accumulated during autoclaving may cause an
electric shock.
Always hold the transducer plug when connecting or
disconnecting the transducer plug to/from the ultrasonic
generator. Otherwise, excessive bending, straining, twisting
or crushing force may disconnect the cable.
Be sure to fully insert the transducer plug securely.
Otherwise, the unsecure connection may result in
unexpected disconnection of the transducer plug, resulting in
no output which could lead to potential bleeding.
Connecting the THUNDERBEAT to the ultrasonic generator
1. Checking the position and symbol 1
Confirm that the symbol 1 for THUNDERBEAT on the transducer plug and
transducer socket are identical (see Figure 3.20).
Figure 3.20
2. Connecting the transducer plug
Fully insert the transducer plug into the transducer socket of the ultrasonic
generator until it is fully seated.
Connecting the SONICBEAT to the ultrasonic generator
1. Checking the position and symbol 2
Confirm that the symbol 2 for SONICBEAT on the transducer plug and
transducer socket are identical (see Figure 3.21).
To Next Page
Loading...
