Installaon, Operaon and Maintenance Manual ManA‐en Rev.03/2018
Page 10
Our products are manufactured under ISO-9001 Quality Assurance System, approved by CSQ certified under no.9190.OMC2 - FIRST ISSUE 1994/08/04
OMC s.r.l. Via G. Galilei, 18 - 20060 - Cassina de Pecchi (MI) - ITALY - www.omcsrl.com - Tel.: (+39) 02.95.28.468
ENGLISH
4.0 REPLACEMENT OF THE DIAPHRAGM
Separate the actuator from the valve as described in paragraph 4.01
By referring to Pic.17 for the direct-action actuators and to Pic.18 for the reverse-action actuators, perform the
following operations:
ATTENTION!!! Tensioned springs
gradually unscrew the bolts (1) in criss-cross sequence
extract the lid (2) unscrew the nut (3) which blocks the plate (5) and replace the diaphragm (4).
if required, replace the v-ring inside the stem-guide (7)
re-assemble everything by performing the operations in the reverse order.
Attention: for valves provided with bellows, in order to prevent any damages to the bellows, make sure that the
plug stem (6) does not rotate.
For the tightening forces refer to chapter 6
Pic. 17 Direct-action actuator Pic. 18 Reverse-action actuator
7
7
To Next Page
Loading...