24
Troubleshooting
Cooler vibrates and/or
makes noises.
It is not correctly leveled
on a rm and at surface.
Cooler stability. Make sure you place
cooler on a rm and at
surface.
No objects are kept under
cooler that might cause
instability.
Remove any carpeting,
carton, or other objects
from under cooler.
Level supports are
unleveled.
Leveling supports are
correctly adjusted.
Adjust leveling supports
until 4 support points are
rm.
Loose parts vibrate or
against surfaces or walls.
Loose components. Locate and tighten loose
parts or adjust those that
might hit others.
Tubing vibration is
transmitted.
N/A. Separate parts that
due to contact may be
vibrating together.
Lighting turns o. It is set in energy saving
mode.
It is not necessary to
check anything, operation
is normal.
When door opens, energy
savings mode will be
deactivated.
Equipment works
continuously for long
periods of time.
Condenser coil is dirty. N/A. Clean coil to remove
dust, lint and waste.
Evaporator coil blocked
by frost or frozen.
Door closure and seals
are rm and adequate
throughout perimeter.
Turn cooler o to defrost
coil. Do not to use a
cutter knife or blade for
handling. Inappropriate
use may scratch or cut o
components.
Doors remain open for a
long time or doors don’t
close.
Doors closed when not
used.
Do not allow doors
to remain open for
prolonged periods of
time.
Door magnetic seals do
not close or seal.
Seal wear. Adjust door or change
seals, if necessary.
Hot product load in
cabinet is excessive.
N/A. Allow enough time to cool
product.
To Next Page
Loading...
Need help?
General
