16
Installation
Operation
Omcan coolers with HC refrigerants (R290 / R600) are designed to operate under a specic electric voltage.
Check cooler’s serial label to make sure that the electrical classication is adequate for installation.
IMPORTANT: ground connection is a protection system for equipment connected to electrical network.
It is used in electrical installations to avoid current pass-through to user due to an isolation failure of
active conductors.
• This cooler must be connected to physical ground. In case a short circuit occurs, ground connection
reduces the risk of electrical shock.
• Cooler is equipped with a power cord with a ground cable with a physical ground connection plug. Plug
must be connected to an adequately-installed outlet and ground connected; if you don’t have this type of
plug, it is your responsibility and obligation to have it installed.
• Please contact a certied electrician or a certied technician if you have questions about ground
connections.
• Never use extension cords, as that action will void the warranty.
• Under no circumstances cut o or remove the third ground connection pin from power cord. Do not use an
adapter; if this recommendation is not followed, it may cause burns or death to user due to electrical shock.
• For optimal operation, it is recommended to have this equipment connected to a dedicated circuit outlet
that is for cooler use only.
• Connect plug rmly to electrical outlet making sure it is inserted all the way in.
POWER CORD
Cooler is equipped with a polarized power cord, with ground connection. Do not attempt to eliminate ground
connection or use two-terminal adapters.
AVOID RISKS: if the power cord or other electronic components are damaged, only the manufacturer
or authorized technician may repair them to avoid danger.
TURNING ON THE COOLER
After having transported and installed the cooler, let it stand for at least twelve hours to allow
compressor oil to fully settle.
Once the installing instructions have been followed, connect the cooler per electrical specications indicated on
serial number label (placed inside cabinet). For your own safety, avoid touching the device with wet hands or
damp or feet. You should not handle cooler when barefoot.
To Next Page
Loading...
Need help?
General
