23
Maintenance
be cleaned o with water and degreasing agents.
• Do not use sharp pointed objects to remove excessive grime, use brush if required.
IMPORTANT: do not use solvent or abrasive products for cleaning as they may damage surface
nishing.
EVAPORATOR DEICING
• Cooler has an automatic evaporator deicing system to guarantee adequate interior air ow.
• If you notice that the cooler is forming ice and it does not cool properly, report this issue to the Customer
Service Center.
MANUAL DEFROSTING - FOR FREEZER
1. Remove the front grill.
2. Push and hold the button 10 for seconds. Manual defrosting is activated by pressing 10 seconds the night
mode button. To observe that the same temperature remains in the control CIF before the defrost cycle.
3. Check that the red and green LEDs illuminate at the same time. During the defrost cycle, green and red
LED remain on.
IT IS IMPORTANT TO KNOW THAT:
It is disabled by time or by temperature, whichever occurs rst:
- Time limit: 30 minutes.
- Temperature at defrost sensor limit: 41°F (5°C).
• Defrost time 12 minutes.
• Drip time 5 minutes.
• Sweep time 5 minutes (fan turn after 5 minutes have ended the defrost).
• After 10 minutes of nishing the defrost compressor kicks in.
TECHNICAL MAINTENANCE
• If your cooler requires major maintenance due to refrigeration, electric or lighting system failure, please
contact the Customer Service Center.
• All repairs must be performed by an authorized technician. Attempts to repair this equipment by
inexperienced personnel or yourself may create malfunctions, damage to equipment or to yourself. Such
attempts will be considered to automatically void the warranty.
• Request and make sure original spare parts are used with the same characteristics to guarantee the
cooler’s optimal operation.
• Before calling the Customer Service Center, check the Troubleshooting Guides included in this manual.
To Next Page
Loading...
Need help?
General
