24
Troubleshooting
Failure Possible Causes Check Corrective Actions
Cooler cannot be turned
on.
Power supply failure. Electric power in the
business.
Wait until electricity
service is restored.
Cooler is not well
connected.
Outlet must have
electrical power.
Loose connection. Plug is well connected. Correctly connect plug to
contact.
Just connected and no
more than 5 minutes
have passed.
N/A. Wait for at least 5 minutes
for compressor to start
running.
Burned fuse or tripped
circuit breaker.
Physical state of fuse or
circuit breaker.
Replace fuse or reset
circuit breaker.
Cooler vibrates and/or
makes noises.
It is not correctly leveled
on a rm and at surface.
Cooler stability. Make sure you place
cooler on a rm and at
surface.
No objects are kept under
cooler that might cause
instability.
Remove any carpeting,
carton, or other objects
from under cooler.
Level supports are
unleveled.
Leveling supports are
correctly adjusted.
Adjust leveling supports
until 4 support points are
rm.
Loose parts vibrate or
against surfaces or walls.
Loose components. Locate and tighten loose
parts or adjust those that
might hit others.
Tubing vibration is
transmitted.
N/A. Separate parts that
due to contact may be
vibrating together.
Lighting turns o. It is set in energy saving
mode.
It is not necessary to
check anything, operation
is normal.
When door opens, energy
savings mode will be
deactivated.
To Next Page
Loading...
Need help?
General
