EasyManuals Logo

Omega Engineering Rercorder RD8300 User Manual

Default Icon
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
Section 6 - Communication
Page 90 09/11/2008 REV 0.99
6.5 Utility Programs
The utility programs provide a method of communicating with the recorder to move data or control operation
remotely. The programs are on the CD that came with the unit. To install the programs, insert the CD in the Drive
(Windows based PCs) and it should auto launch. If it does not, run the program CD_Start.exe on the CD. The
setup program has various options as shown below:
Fig 6.5 Recorder Setup Program
6.5.1 FTP Manager
FTP is short for File Transfer Protocol a standard for file transfer over the internet.
The FTP manager is a standalone file manager for
uploading and downloading files from remote
recorders. It is installed from the installation disk that
came with the recorder. Refer to Fig 6.5 above. Click
the “FTP Manager Setup” button This will launch
the installer. Follow the instructions and use the
default file location as shown left.
Click “Next” and the installation will proceed. Once
installation is complete, click “Close” to finish.
If you selected the add icon option during installation
it will appear on your desktop

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omega Engineering Rercorder RD8300 and is the answer not in the manual?

Omega Engineering Rercorder RD8300 Specifications

General IconGeneral
BrandOmega Engineering
ModelRercorder RD8300
CategoryRecording Equipment
LanguageEnglish